28.265—Emergency instructions.
(a)
Except as provided in paragraphs (b) and (c) of this section, each vessel must have emergency instructions posted in conspicuous locations accessible to the crew.
(b)
The instructions identified in paragraphs (d)(6), (d)(7), (d)(8), and (d)(9) of this section, may be kept readily available as an alternative to posting.
(c)
On a vessel which operates with less than 4 individuals on board, the emergency instructions may be kept readily available as an alternative to posting.
(d)
The emergency instructions required by this section must identify at least the following information, as appropriate for the vessel:
(1)
The survival craft embarkation stations aboard the vessel and the survival craft to which each individual is assigned;
(3)
If immersion suits are provided, the location of the suits and illustrated instructions on the method for donning the suits;
(ii)
Select 156.8 MHz (VHF channel 16), 2182 kHz, or other distress frequency used in your area of operation. Note: VHF channel 16 and 2182 kHz on SSB are for emergency and calling purposes only.
“Mayday—Mayday—Mayday”
(iv)
Say: “This is the M/V (Insert name of your vessel), (Insert name of your vessel), (Insert name of your vessel), Over.”
(v)
Release the microphone button briefly and listen for acknowledgment. If no one answers, repeat steps in paragraphs (d)(4) (iii) and (iv) of this section.
(vi)
If there is still no answer, or if the Coast Guard or another vessel responds, say: “Mayday—This is the M/V (Insert Name of Your Vessel).”
(vii)
Describe your position using latitude and longitude coordinates, or range and bearing from a known point.
(xi)
Describe your vessel: (Insert length, color, hull type, trim, masts, power, and any additional distinguishing features).
(xiv)
If your situation permits, stand by the radio to await further communication with the Coast Guard or another vessel. If no answer, repeat, then try another channel.
(ii)
Closing of hatches, airports, watertight doors, vents, scuppers, and valves for intake and discharge lines which penetrate the hull, stopping of fans and ventilation systems, and operation of all safety equipment.
(6)
The procedures for rough weather at sea, crossing hazardous bars, flooding, and anchoring of the vessel, such as:
(i)
Close all watertight and weathertight doors, hatches and airports to prevent taking water aboard or further flooding in the vessel.
(ii)
Keep bilges dry to prevent loss of stability due to water in bilges. Use power driven bilge pump, hand pump, and buckets to dewater.
(vi)
Personnel should don lifejackets and immersion suits if the going becomes very rough, the vessel is about to cross a hazardous bar, or when otherwise instructed by the master or individual in charge of the vessel.
(iv)
Have a crewmember put on a lifejacket or immersion suit, attach a safety line to the crewmember, and have the crewmember standby to jump into the water to assist in recovering the individual in the water if necessary;
(v)
If the individual overboard is not immediately located, notify the Coast Guard and other vessels in the vicinity; and
(iii)
Immediately use a portable fire extinguisher or use water for fires in ordinary combustible materials. Do not use water on electrical fires.
(iv)
If the fire is in a machinery space, shut off the fuel supply and ventilation system and activate the fixed extinguishing system, if installed.
(vi)
If unable to control the fire, immediately notify the Coast Guard and other vessels in the vicinity.
(vii)
Move personnel away from the fire, have them put on lifejackets, and if necessary, prepare to abandon the vessel.
[CGD 88-079, 56 FR 40393, Aug. 14, 1991, as amended by USCG-2010-0759, 75 FR 60002, Sept. 29, 2010]