11.63—Injury determination phase—pathway determination.
(a) General.
(1)
To determine the exposure pathways of the oil or hazardous substance, the following shall be considered:
(i)
The chemical and physical characteristics of the discharged oil or released hazardous substance when transported by natural processes or while present in natural media;
(ii)
The rate or mechanism of transport by natural processes of the discharged oil or released hazardous substance; and
(iii)
Combinations of pathways that, when viewed together, may transport the discharged oil or released hazardous substance to the resource.
(2)
The pathway may be determined by either demonstrating the presence of the oil or hazardous substance in sufficient concentrations in the pathway resource or by using a model that demonstrates that the conditions existed in the route and in the oil or hazardous substance such that the route served as the pathway.
(3)
To the extent that the information needed to make this determination is not available, tests shall be conducted and necessary data shall be collected to meet the requirements of this section. Methods that may be used to conduct these additional tests and collect new information are described in § 11.64 of this part.
(b) Surface water pathway.
(1)
When the surface water resource is suspected as the pathway or a component of the pathway, the authorized official shall determine, using guidance provided in this paragraph, whether the surface water resource, either solely or in combination with other media, served as the exposure pathway for injury to the resource.
(2)
(i)
Using available information and such additional tests as necessary, it should be determined whether the surface water resource downstream or downcurrent of the source of discharge or release has been exposed to the oil or hazardous substance.
(ii)
When the source of discharge or release is on an open water body, such as a marsh, pond, lake, reservoir, bay, estuary, gulf, or sound, it should be determined, using available information and such additional tests as necessary, whether the surface water resource in the vicinity of the source of discharge or release has been exposed to the oil or hazardous substance.
(3)
(i)
If a surface water resource is or likely has been exposed, the areal extent of the exposed surface water resource should be estimated, including delineation of:
(B)
Bed sediment and suspended sediment characteristics, including grain size, grain mineralogy, and chemistry of grain surfaces;
(C)
Volume, inflow-outflow rates, degree of stratification, bathymetry, and bottom sediment characteristics of surface water bodies;
(D)
Suspended sediment concentrations and loads and bed forms and loads of streams and tidally affected waters; and
(4)
(i)
Using available information and data from additional tests as necessary, the mobility of the oil or hazardous substance in the exposed surface water resource should be estimated. This estimate should consider such physical and chemical characteristics of the oil or hazardous substance as aqueous solubility, aqueous miscibility, density, volatility, potential for chemical degradation, chemical precipitation, biological degradation, biological uptake, and adsorption.
(ii)
Previous studies of the characteristics discussed in paragraph (b)(4)(i) of this section should be relied upon if hydraulic, physical, and chemical conditions in the exposed surface water resource are similar to experimental conditions of the previous studies. In the absence of this information, those field and laboratory studies necessary to estimate the mobility of the oil or hazardous substance in surface water flow may be performed.
(5)
(i)
The rate of transport of the oil or hazardous substance in surface water should be estimated using available information and with consideration of the hydraulic properties of the exposed resource and the physical and chemical characteristics of the oil or hazardous substance.
(A)
The results of previous time-of-travel and dispersion studies made in the exposed surface water resource before the discharge or release;
(B)
The results of previous studies, conducted with the same or similar chemical substances to those discharged or released under experimental conditions similar to the hydraulic, chemical, and biological conditions in the exposed surface water resource;
(C)
The results of field measurements of time-of-travel and dispersion made in the exposed or comparable surface water resource, using natural or artificial substances with transport characteristics that reasonably approximate those of the oil or hazardous substance; and
(D)
The results of simulation studies using the results of appropriate time-of-travel and dispersion studies in the exposed or comparable surface water resource.
(c) Ground water pathway.
(1)
When ground water resources are suspected as the pathway or a component of the pathway, the authorized official shall determine, using guidance provided in this paragraph, whether ground water resources, either solely or in combination with other media, served as the exposure pathway for injury to the resource.
(2)
Using available information and such additional tests as necessary, it should be determined whether the unsaturated zone, the ground water, or the geologic materials beneath or downgradient of the source of discharge or release have been exposed to the oil or hazardous substance.
(3)
If a ground water resource is or likely has been exposed, available information and such additional tests should be used as necessary to determine the characteristics of the unsaturated zone, as well as any aquifers and confining units containing the exposed ground water, in the vicinity of the source of discharge or release. The characteristics of concern include:
(vi)
Lithology, mineralogy, and porosity of rocks or sediments comprising the unsaturated zone, aquifers, and confining units;
(viii)
Nature and amount of hydraulic connection between ground water and local surface water resources.
(4)
(i)
Using available information and such additional tests as necessary, the mobility of the oil or hazardous substance within the unsaturated zone and in the exposed ground water resources should be estimated. This estimate should consider local recharge rates and such physical and chemical characteristics of the oil or hazardous substance as aqueous solubility, aqueous miscibility, density, volatility, potential for chemical degradation, chemical precipitation, biological degradation, biological uptake, and adsorption onto solid phases in the unsaturated zone, aquifers, and confining units.
(ii)
Previous studies of the characteristics discussed in paragraph (c)(4)(i) of this section should be relied upon if geohydrologic, physical, and chemical conditions in the exposed ground water resource are similar to experimental conditions of the previous studies. In the absence of this information, field and laboratory studies may be performed as necessary to estimate the mobility of the oil or hazardous substance within the unsaturated zone and in ground water flows.
(5)
(i)
The rate of transport of the oil or hazardous substance in ground water should be estimated using available information and with consideration of the site hydrology, geohydrologic properties of the exposed resource, and the physical and chemical characteristics of the oil or hazardous substance.
(A)
Results of previous studies conducted with the same or similar chemical substance, under experimental geohydrological, physical, and chemical conditions similar to the ground water resource exposed to the oil or hazardous substance;
(B)
Results of field measurements that allow computation of arrival times of the discharged or released substance at downgradient wells, so that an empirical transport rate may be derived; or
(C)
Results of simulation studies, including analog or numerical modeling of the ground water system.
(d) Air pathway.
(1)
When air resources are suspected as the pathway or a component of the pathway, the authorized official shall determine, using guidance provided in this paragraph, whether the air resources either solely or in combination with other media, served as the exposure pathway for injury to the resource.
(2)
Using available information, air modeling, and additional field sampling and analysis, it should be determined whether air resources have been exposed to the discharge of oil or release of a hazardous substance.
(3)
(i)
If an air resource is or has likely been exposed, available information and such additional tests as necessary should be used to estimate the areal extent of exposure and the duration and frequency of exposure of such areas to emissions from the discharge of oil or release of a hazardous substance.
(ii)
The areal extent of exposure is defined as the geographical surface area or space where emissions from the source of discharge or release are found or otherwise determined to be present for such duration and frequency as to potentially result in injury to resources present within the area or space.
(4)
Previous studies of the characteristics discussed in paragraph (d)(3)(i) of this section should be relied upon if the conditions in the exposed air resource are similar to experimental conditions of the previous studies. In the absence of this information, air sampling and analysis methods identified in § 11.64(d) of this part, air modeling methods, or a combination of these methods may be used in identifying the air exposure pathway and in estimating the areal extent of exposure and duration and frequency of exposure.
(5)
For estimating the areal extent, duration, and frequency of exposure from the discharge or release, the following factors shall be considered as may be appropriate for each emissions event:
(i)
The manner and nature in which the discharge or release occurs, including the duration of the emissions, amount of the discharge or release, and emergency or other time critical factors;
(ii)
The configuration of the emitting source, including sources such as ponds, lagoons, pools, puddles, land and water surface spills, and venting from containers and vessels;
(iii)
Physical and chemical properties of substances discharged or released, including volatility, toxicity, solubility, and physical state;
(iv)
The deposition from the air and re-emission to the air of gaseous and particulate emissions that provide periodic transport of the emissions; and
(v)
Air transport and dispersion factors, including wind speed and direction, and atmospheric stability and temperature.
(e) Geologic pathway.
(1)
When geologic resources are suspected as the pathway or a component of the pathway, the authorized official shall determine, using guidance provided in this paragraph, whether geologic resources, either solely or in combination with other media, served as the exposure pathway for injury to the resource.
(2)
(i)
Using available information and the methods listed in § 11.64(e) of this part, it should be determined whether any element of the geologic resource has been exposed to the oil or hazardous substance. If a geologic resource is or has likely been exposed, the areal extent of the exposed geologic resource, including the lateral and vertical extent of the dispersion, should be estimated.
(ii)
To determine whether the unsaturated zone served as a pathway, the guidance provided in paragraph (c) of this section should be followed.
(f) Biological pathway.
(1)
When biological resources are suspected as the pathway or a component of the pathway, the authorized official shall determine, using the guidance provided in this paragraph, whether biological resources, either solely or in combination with other media, served as the exposure pathway for injury to the resource.
(2)
Biological pathways that resulted from either direct or indirect exposure to the oil or hazardous substance, or from exposure to products of chemical or biological reactions initiated by the discharge or release shall be identified. Direct exposure can result from direct physical contact with the discharged oil or released hazardous substance. Indirect exposure can result from food chain processes.
(3)
If the oil or hazardous substance adhered to, bound to, or otherwise covered surface tissue, or was ingested, or inhaled but not assimilated, the area of dispersion may be determined based upon chemical analysis of the appropriate tissues or organs (such as leaves, lungs, stomach, intestine, or their contents) that were directly exposed to the oil or hazardous substance.
(4)
If the oil or hazardous substance was assimilated, the areal dispersion may be determined based upon one or more of the following alternative procedures:
(i)
If direct exposure to the biological resource has occurred, chemical analysis of the organisms that have been exposed may be performed.
(ii)
If indirect exposure to the biological resource has occurred, either chemical analysis of free-ranging biological resources using one or more indicator species as appropriate, or laboratory analysis of one or more in situ placed indicator species as appropriate may be performed.
(A)
Indicator species, as used in this section, means a species of organism selected consistent with the following factors to represent a trophic level of a food chain:
(1) General availability of resident organisms in the assessment area;
(2) Potential for exposure to the oil or hazardous substance through ingestion, assimilation, or inhalation;
(3) Occurrence of the substance in a chemical form that can be assimilated by the organism;
(4) Capacity of the organism to assimilate, bioconcentrate, bioaccumulate, and/or biomagnify the substance;
(5) Capacity of the organism to metabolize the substance to a form that cannot be detected through available chemical analytical procedures; and
(6) Extent to which the organism is representative of the food chain of concern.
(B)
Collection of the indicator species should be limited to the number necessary to define the areal dispersion and to provide sufficient sample volume for chemical analysis.
(C)
When in situ procedures are used, indicator species that behave comparably to organisms existing under free-ranging conditions shall be collected. The indicator species used in this procedure shall be obtained either from a control area selected consistent with provisions of § 11.72 of this part or obtained from a suitable supply of wild-strain organisms reared in a laboratory setting. Appropriate chemical analysis shall be performed on a representative subsample of the indicator species before in situ placement.
(iii)
In situ placement procedures shall be used where the collection of samples would be inconsistent with the provisions of § 11.17(b) of this part.
(5)
Sampling sites and the number of replicate samples to be collected at the sampling sites shall be consistent with the quality assurance provisions of the Assessment Plan.
(6)
Chemical analysis of biological resource samples collected for the purpose of this section shall be conducted in accordance with the quality assurance provisions of the Assessment Plan.