98.56—Data reporting requirements.

In addition to the information required by § 98.3(c), each annual report must contain the information specified in paragraphs (a) through (l) of this section at the facility level.
(a) Annual process N2 O emissions from adipic acid production (metric tons).
(b) Annual adipic acid production (tons).
(c) Annual adipic acid production during which N2 O abatement technology (located after the test point) is operating (tons).
(d) Annual process N2 O emissions from adipic acid production facility that is sold or transferred off site (metric tons).
(e) Number of abatement technologies (if applicable).
(f) Types of abatement technologies used (if applicable).
(g) Abatement technology destruction efficiency for each abatement technology (percent destruction).
(h) Abatement utilization factor for each abatement technology (fraction of annual production that abatement technology is operating).
(i) Number of times in the reporting year that missing data procedures were followed to measure adipic acid production (months).
(j) If you conducted a performance test and calculated a site-specific emissions factor according to § 98.53(a)(1), each annual report must also contain the information specified in paragraphs (j)(1) through (7) of this section for each adipic acid production unit.
(1) Emission factor (lb N2 O/ton adipic acid).
(2) Test method used for performance test.
(3) Production rate per test run during performance test (tons/hr).
(4) N2 O concentration per test run during performance test (ppm N2 O).
(5) Volumetric flow rate per test run during performance test (dscf/hr).
(6) Number of test runs.
(7) Number of times in the reporting year that a performance test had to be repeated (number).
(k) If you requested Administrator approval for an alternative method of determining N2 O emissions under § 98.53(a)(2), each annual report must also contain the information specified in paragraphs (k)(1) through (4) of this section for each adipic acid production facility.
(1) Name of alternative method.
(2) Description of alternative method.
(3) Request date.
(4) Approval date.
(l) Fraction control factor for each abatement technology (percent of total emissions from the production unit that are sent to the abatement technology) if equation E-3c is used.

Code of Federal Regulations

[74 FR 56374, Oct. 30, 2009, as amended at 75 FR 66460, Oct. 28, 2010]