98.296—Data reporting requirements.
In addition to the information required by § 98.3(c), each annual report must contain the information specified in paragraphs (a) or (b) of this section, as appropriate for each soda ash manufacturing facility.
(a)
If a CEMS is used to measure CO2 emissions, then you must report under this subpart the relevant information required under § 98.36 and the following information in this paragraph (a):
(b)
If a CEMS is not used to measure CO2 emissions, then you must report the information listed in this paragraph (b):
(7)
Inorganic carbon content factor of trona or soda ash (depending on use of Equations CC-1 or CC-2 of this subpart) as measured by the applicable method in § 98.294(b) or (c) for each month (percent by weight expressed as a decimal fraction).
(8)
Whether CO2 emissions for each manufacturing line were calculated using a trona input method as described in Equation CC-1 of this subpart, a soda ash output method as described in Equation CC-2 of this subpart, or a site-specific emission factor method as described in Equations CC-3 through CC-5 of this subpart.
(10)
If you produce soda ash using the liquid alkaline feedstock process and use the site-specific emission factor method ( § 98.293(b)(3)) to estimate emissions then you must report the following relevant information for each manufacturing line or stack:
(iii)
CO2 emission factor (metric tons CO2 /metric tons of process vent flow from mine water stripper/evaporator).
(11)
Number of times missing data procedures were used and for which parameter as specified in this paragraph (b)(11):