98.226—Data reporting requirements.
In addition to the information required by § 98.3(c), each annual report must contain the information specified in paragraphs (a) through (p) of this section.
(d)
Annual nitric acid production from each nitric acid train during which N2 O abatement technology is operating (ton acid produced, 100 percent acid basis).
(i)
Abatement technology destruction efficiency for each abatement technology (percent destruction).
(j)
Abatement utilization factor for each abatement technology (fraction of annual production that abatement technology is operating).
(k)
Type of nitric acid process used for each nitric acid train (low, medium, high, or dual pressure).
(l)
Number of times in the reporting year that missing data procedures were followed to measure nitric acid production (months).
(m)
If you conducted a performance test and calculated a site-specific emissions factor according to § 98.223(a)(1), each annual report must also contain the information specified in paragraphs (m)(1) through (7) of this section.
(1)
Emission factor calculated for each nitric acid train (lb N2 O/ton nitric acid, 100 percent acid basis).
(3)
Production rate per test run during performance test (tons nitric acid produced/hr, 100 percent acid basis).
(n)
If you requested Administrator approval for an alternative method of determining N2 O emissions under § 98.223(a)(2), each annual report must also contain the information specified in paragraphs (n)(1) through (4) of this section.(n)(1) through (n)(4) of this section for each nitric acid production facility.
(p)
Fraction control factor for each abatement technology (percent of total emissions from the production unit that are sent to the abatement technology) if equation V-3c is used.