CFR > Title 40 - Protection of Environment > CHAPTER I—ENVIRONMENTAL PROTECTION AGENCY > SUBCHAPTER C—AIR PROGRAMS (Parts 50–99) > PART 92—CONTROL OF AIR POLLUTION FROM LOCOMOTIVES AND LOCOMOTIVE ENGINES > SUBPART G—In-Use Testing Program (§92.601 to §92.607) > 92.607—In-use test program reporting requirements.

92.607—In-use test program reporting requirements.

(a) The manufacturer or remanufacturer shall submit to the Administrator within three (3) months of completion of testing all emission testing results generated from the in-use testing program. The following information must be reported for each locomotive tested:
(1) Engine family, and configuration;
(2) Locomotive and engine models;
(3) Locomotive and engine serial numbers;
(4) Date of manufacture and/or remanufacture(s), as applicable;
(5) Megawatt-hours of use (or miles, as applicable);
(6) Date and time of each test attempt;
(7) Results (if any) of each test attempt;
(8) Results of all emission testing;
(9) Summary of all maintenance and/or adjustments performed;
(10) Summary of all modifications and/or repairs;
(11) Determinations of noncompliance; and
(12) The following signed statement and endorsement by an authorized representative of the manufacturer or remanufacturer:
This report is submitted pursuant to Sections 213 and 208 of the Clean Air Act. This in-use testing program was conducted in complete conformance with all applicable regulations under 40 CFR part 92. All data and information reported herein is, to the best of (Company Name) knowledge, true and accurate. I am aware of the penalties associated with violations of the Clean Air Act and the regulations thereunder. (Authorized Company Representative.)
(b) The manufacturer or remanufacturer shall report to the Administrator within three (3) months of completion of testing the following information for each engine family tested:
(1) The serial numbers of all locomotive that were excluded from the test sample because they did not meet the maintenance requirements of § 92.606 ;
(2) The owner of each locomotive identified in paragraph (b)(1) of this section (or other entity responsible for the maintenance of the locomotive); and
(3) The specific reasons why the locomotives were excluded from the test sample.
(c) The manufacturer or remanufacturer must submit, via floppy disk, the information outlined in paragraphs (a) and (b) of this section using a pre-approved information heading. The Administrator may exempt manufacturers or remanufacturers from this requirement upon written request with supporting justification.
(d) All testing reports and requests for approvals made under this subpart shall be addressed to: Group Manager, Engine Compliance Programs Group, Engine Programs and Compliance Division, U.S. Environmental Protection Agency, 6403-J, 1200 Pennsylvania Ave., NW., Washington, DC 20460.