1042.230—Engine families.
(a)
For purposes of certification, divide your product line into families of engines that are expected to have similar emission characteristics throughout the useful life as described in this section. You may not group engines in different engine categories in the same family. Your engine family is limited to a single model year.
(b)
For Category 1 engines, group engines in the same engine family if they are the same in all the following aspects:
(7)
Cylinder arrangement (such as in-line vs. vee configurations). This applies for engines with aftertreatment devices only.
(10)
Numerical level of the emission standards that apply to the engine, except as allowed under paragraphs (f) and (g) of this section.
(c)
For Category 2 engines, group engines in the same engine family if they are the same in all the following aspects:
(2)
The fuel with which the engine is intended or designed to be operated and the fuel system configuration.
(3)
The cooling system (for example, air-cooled or water-cooled), and procedure(s) employed to maintain engine temperature within desired limits (thermostat, on-off radiator fans, radiator shutters, etc.).
(5)
The turbocharger or supercharger general performance characteristics (e.g., approximate boost pressure, approximate response time, approximate size relative to engine displacement).
(6)
The type of air inlet cooler (air-to-air, air-to-liquid, approximate degree to which inlet air is cooled).
(7)
The type of exhaust aftertreatment system (oxidation catalyst, particulate trap), and characteristics of the aftertreatment system (catalyst loading, converter size vs. engine size).
(8)
The combustion chamber configuration and the surface-to-volume ratio of the combustion chamber when the piston is at top dead center position, using nominal combustion chamber dimensions.
(18)
The overall injection timing characteristics, or as appropriate ignition timing characteristics (i.e., the deviation of the timing curves from the optimal fuel economy timing curve must be similar in degree).
(d)
For Category 3 engines, group engines into engine families based on the criteria specified in Section 4.3 of the NOX Technical Code (incorporated by reference in § 1042.910 ), except as allowed in paragraphs (e) and (f) of this section.
(e)
You may subdivide a group of engines that is identical under paragraph (b) or (c) of this section into different engine families if you show the expected emission characteristics are different during the useful life. However, for the purpose of applying small-volume family provisions of this part, we will consider the otherwise applicable engine family criteria of this section.
(f)
You may group engines that are not identical with respect to the things listed in paragraph (b), (c), or (d) of this section in the same engine family, as follows:
(1)
In unusual circumstances, you may group such engines in the same engine family if you show that their emission characteristics during the useful life will be similar.
(2)
If you are a small-volume engine manufacturer, you may group any Category 1 engines into a single engine family or you may group any Category 2 engines into a single engine family. This also applies if you are a post-manufacture marinizer modifying a base engine that has a valid certificate of conformity for any kind of nonroad or heavy-duty highway engine under this chapter.
(3)
The provisions of this paragraph (f) do not exempt any engines from meeting the standards and requirements in subpart B of this part.
(g)
If you combine engines that are subject to different emission standards into a single engine family under paragraph (f) of this section, you must certify the engine family to the more stringent set of standards for that model year. For Category 3 engine families that include a range of maximum in-use engine speeds, use the highest value of maximum in-use engine speed to establish the applicable NOX emission standard.