1033.235—Emission testing required for certification.
This section describes the emission testing you must perform to show compliance with the emission standards in § 1033.101.
(a)
Select an emission-data locomotive (or engine) from each engine family for testing. It may be a low mileage locomotive, or a development engine (that is equivalent in design to the engines of the locomotives being certified), or another low hour engine. Use good engineering judgment to select the locomotive configuration that is most likely to exceed (or have emissions nearest to) an applicable emission standard or FEL. In making this selection, consider all factors expected to affect emission control performance and compliance with the standards, including emission levels of all exhaust constituents, especially NOX and PM.
(b)
Test your emission-data locomotives using the procedures and equipment specified in subpart F of this part.
(c)
We may measure emissions from any of your emission-data locomotives or other locomotives from the engine family.
(1)
We may decide to do the testing at your plant or any other facility. If we do this, you must deliver the locomotive to a test facility we designate. If we do the testing at your plant, you must schedule it as soon as possible and make available the instruments, personnel, and equipment we need.
(2)
If we measure emissions from one of your locomotives, the results of that testing become the official emission results for the locomotive. Unless we later invalidate these data, we may decide not to consider your data in determining if your engine family meets applicable requirements.
(3)
Before we test one of your locomotives, we may set its adjustable parameters to any point within the adjustable ranges (see § 1033.115(b) ).
(4)
Before we test one of your locomotives, we may calibrate it within normal production tolerances for anything we do not consider an adjustable parameter. For example, this would apply where we determine that an engine parameter is not an adjustable parameter (as defined in § 1033.901) but that it is subject to production variability.
(d)
You may ask to use carryover emission data from a previous model year instead of doing new tests if all the following are true:
(1)
The engine family from the previous model year differs from the current engine family only with respect to model year, or other factors not related to emissions. You may include additional configurations subject to the provisions of § 1033.225.
(2)
The emission-data locomotive from the previous model year remains the appropriate emission-data locomotive under paragraph (b) of this section.
(3)
The data show that the emission-data locomotive would meet all the requirements that apply to the engine family covered by the application for certification.
(e)
You may ask to use emission data from a different engine family you have already certified instead of testing a locomotive in the second engine family if all the following are true:
(2)
You demonstrate to us that the differences in the two families are sufficiently small that the locomotives in the untested family will meet the same applicable notch standards calculated from the test data.
(f)
We may require you to test a second locomotive of the same or different configuration in addition to the locomotive tested under paragraph (b) of this section.
(g)
If you use an alternate test procedure under 40 CFR 1065.10 and later testing shows that such testing does not produce results that are equivalent to the procedures specified in subpart F of this part, we may reject data you generated using the alternate procedure.
(h)
The requirement to measure smoke emissions is waived for certification and production line testing, except where there is reason to believe your locomotives do not meet the applicable smoke standards.
(i)
Measure CO2 with each test. Measure CH4 with each low-hour certification test using the procedures specified in 40 CFR part 1065 starting in the 2012 model year. Also measure N2 O with each low-hour certification test using the procedures specified in 40 CFR part 1065 for any engine family that depends on NOx aftertreatment to meet emission standards. Small manufacturers/remanufacturers may omit measurement of N2 O and CH4. Use the same units and modal calculations as for your other results to report a single weighted value for CO2, N2 O, and CH4. Round the final values as follows: