70.207—Bimonthly sampling; mechanized mining units.
(a)
Each operator shall take five valid respirable dust samples from the designated occupation in each mechanized mining unit during each bimonthly period beginning with the bimonthly period of November 1, 1980. Designated occupation samples shall be collected on consecutive normal production shifts or normal production shifts each of which is worked on consecutive days. The bimonthly periods are:
January 1-February 28 (29)
March 1-April 30
May 1-June 30
July 1-August 31
September 1-October 31
November 1-December 31.
(b)
When the respirable dust standard is changed in accordance with § 70.101 (Respirable dust standard when quartz is present), respirable dust sampling of mechanized mining units shall begin on the first production shift during the next bimonthly period following notification of such change from MSHA.
(c)
Upon issuance of a citation for a violation of § 70.100(a) (Respirable dust standards) or § 70.101 (Respirable dust standard when quartz is present) involving a designated occupation in a mechanized mining unit, paragraphs (a) and (b) of this section shall not apply to that unit until the violation is abated in accordance with § 70.201(d) (Sampling; general requirements).
(d)
Each designated occupation sample shall be taken on a normal production shift. If a normal production shift is not achieved, the sample for that shift may be voided by MSHA. However, any sample, regardless of production, with a respirable dust concentration greater than 2.5 milligrams per cubic meter of air will be used to determine the average concentration for that mechanized mining unit.
(e)
Unless otherwise directed by the District Manager, the designated occupation samples shall be taken by placing the sampling device as follows:
(1) Conventional section using cutting machine.
On the cutting machine operator or on the cutting machine within 36 inches inby the normal working position;
(2) Conventional section shooting off the solid.
On the loading machine operator or on the loading machine within 36 inches inby the normal working position;
(3) Continuous mining section other than auger-type.
On the continuous mining machine operator or on the continuous mining machine within 36 inches inby the normal working position;
(4) Continuous mining machine; auger-type.
On the jacksetter who works nearest the working face on the return air side of the continuous mining machine or at a location that represents the maximum concentration of dust to which the miner is exposed;
(5) Scoop section using cutting machine.
On the cutting machine operator or on the cutting machine within 36 inches inby the normal working position;
(6) Scoop section, shooting off the solid.
On the coal drill operator or on the coal drill within 36 inches inby the normal working position;
(7) Longwall section.
On the miner who works nearest the return air side of the longwall working face or along the working face on the return side within 48 inches of the corner;
(8) Hand loading section with a cutting machine.
On the cutting machine operator or on the cutting machine within 36 inches inby the normal working position;
(9) Hand loading section shooting off the solid.
On the hand loader exposed to the greatest dust concentration or at a location that represents the maximum concentration of dust to which the miner is exposed;
(10) Anthracite mine sections.
On the hand loader exposed to the greatest dust concentration or at a location that represents the maximum concentration of dust to which the miner is exposed.
(f)
(1)
Each mechanized mining unit will be assigned a four digit identification number by MSHA. The mechanized mining unit shall retain that identification number regardless of where the unit relocates within the mine.
(2)
When two sets of mining equipment are provided in a series of working places and only one production crew is employed at any given time on either set of mining equipment, the two sets of equipment shall be identified as a single mechanized mining unit. When two or more mechanized mining units are simultaneously engaged in the production of material within the same working section, each such mechanized mining unit shall be identified separately.