3280.602—Definitions.
The following definitions are applicable to subpart G only:
Accessible, when applied to a fixture, connection, appliance or equipment, means having access thereto, but which may require removal of an access panel or opening of a door.
Air gap (water distribution system) means the unobstructed vertical distance through the free atmosphere between the lowest opening from any pipe or faucet supplying water to a tank, plumbing fixture, water supplied appliances, or other device and the flood level rim of the receptacle.
Anti-siphon trap vent device means a device which automatically opens to admit air to a fixture drain above the connection of the trap arm so as to prevent siphonage, and closes tightly when the pressure within the drainage system is equal to or greater than atmospheric pressure so as to prevent the escape of gases from the drainage system into the manufactured home.
Backflow means the flow of water or other liquids, mixtures, or substances into the distributing pipes of a potable supply of water from any source or sources other than its intended sources.
Backflow connection means any arrangement whereby backflow can occur.
Backflow preventer means a device or means to prevent backflow.
Branch means any part of the piping system other than a riser, main or stack.
Common vent means a vent connecting at the junction of fixture drains and serving as a vent for more than one fixture.
Continuous vent means a vertical vent that is a continuation of the drain to which it connects.
Continuous waste means a drain from two or more fixtures connected to a single trap.
Critical level means a point established by the testing laboratory (usually stamped on the device by the manufacturer) which determines the minimum elevation above the flood level rim of the fixture or receptacle served on which the device may be installed. When a backflow prevention device does not bear a critical level marking, the bottom of the vacuum breaker, combination valve, or of any such approved or listed device shall constitute the critical level.
Cross connection means any physical connection or arrangement between two otherwise separate systems or sources, one of which contains potable water and the other either water, steam, gas or chemical of unknown or questionable safety whereby there may be a flow from one system or source to the other, the direction of flow depending on the pressure differential between the two systems.
Developed length means that length of pipe measured along the center line of the pipe and fittings.
Diameter, unless otherwise specifically stated, means the nominal (inside) diameter designated commercially.
Drain means a pipe that carries waste, water, or water-borne waste in a drainage system.
Drain connector means the removable extension, consisting of all pipes, fittings and appurtenances, from the drain outlet to the drain inlet serving the manufactured home.
Drain outlet means the lowest end of the main or secondary drain to which a sewer connection is made.
Drainage system means all piping within or attached to the structure that conveys sewage or other liquid waste to the drain outlet, not including the drain connector.
Fixture drain means the drain from the trap of a fixture to the junction of that drain with any other drain pipe.
Fixture supply means the water supply pipe connecting a fixture to a branch water supply pipe or directly to a main water supply pipe.
Flood-level means the level in the receptacle over which water would overflow to the outside of the receptacle.
Flooded means the condition which results when the liquid in a container or receptacle rises to the flood-level.
Flush tank means that portion of a water closet that is designed to contain sufficient water to adequately flush the fixture.
Flush valve means a device located at the bottom of a flush tank for flushing a water closet.
Flushometer tank: means a device integrated within an air accumulator vessel which is designed to discharge a predetermined quantity of water to fixtures for flushing purposes.
Flushometer valve means a device which discharges a predetermined quantity of water to a fixture for flushing purposes and is closed by direct water pressure.
Grade means the fall (slope) of a pipe in reference to a horizontal plane expressed in inches per foot length.
Horizontal branch means any pipe extending laterally, which receives the discharge from one or more fixture drains and connects to the main drain.
Horizontal pipe means any pipe or fitting which makes an angle of not more than 45 degrees with the horizontal.
Individual vent means a pipe installed to vent a fixture drain.
Inlet coupling means the terminal end of the water system to which the water service connection is attached. It may be a swivel fitting or threaded pipe end.
Main means the principal artery of the system to which branches may be connected.
Main drain means the lowest pipe of a drainage system which receives sewage from all the fixtures within a manufactured home and conducts these wastes to the drain outlet.
Main vent means the principal artery of the venting system to which vent branches may be connected.
Offset means a combination of pipe and/or fittings that brings one section of the pipe out of line but into a line parallel with the other section.
Pitch. See Grade.
Plumbing appliance: means any one of a special class of plumbing fixture which is intended to perform a special plumbing function. Its operation and/or control may be dependent upon one or more energized components, such as motors, control, heating elements, or pressure or temperature-sensing elements. Such fixture may operate automatically through one or more of the following actions: A time cycle, a temperature range, a pressure range, a measured volume or weight, or the fixture may be manually adjusted or controlled by the user or operator.
Plumbing appurtenance: means a manufactured device, or a prefabricated assembly, or an on-the-job assembly of component parts, and which is an adjunct to the basic piping system and plumbing system and plumbing fixtures. An appurtenance demands no additional water supply, nor does it add any discharge load to a fixture or the drainage system.
Plumbing fixtures means receptacles, devices, or appliances which are supplied with water or which receive liquid or liquid-borne wastes for discharge into the drainage system.
Plumbing system means the water supply and distribution pipes; plumbing fixtures, faucets and traps; soil, waste and vent pipes; and water-treating or water-using equipment.
Primary vent. See main vent.
Relief vent means an auxiliary vent which permits additional circulation of air in or between drainage and vent systems.
Secondary vent means any vent other than the main vent or those serving each toilet.
Sewage means any liquid waste containing animal or vegetable matter in suspension or solution, and may include liquids containing chemicals in solution.
Siphonage means the loss of water seal from fixture traps resulting from partial vacuum in the drainage system which may be of either of the following two types, or a combination of the two:
(a)
Self-siphonage resulting from vacuum in a fixture drain generated solely by the discharge of the fixture served by that drain, or,
(b)
Induced siphonage resulting from vacuum in the drainage system generated by the discharge of one or more fixtures other than the one under observation.
Trap means a fitting or device designed and constructed to provide a liquid seal that will prevent the back passage of air without materially affecting the flow of liquid waste through it.
Trap arm means the portion of a fixture drain between a trap and its vent.
Trap seal means the vertical depth of liquid that a trap will retain.
Vacuum breaker. See backflow preventer.
Vent cap means the device or fitting which protects the vent pipe from foreign substance with an opening to the atmosphere equal to the area of the vent it serves.
Vent system means that part of a piping installation which provides circulation of air within a drainage system.
Vertical pipe means any pipe or fitting which makes an angle of not more than 45 degrees with the vertical.
Water closet drain means that part of the drainage piping which receives the discharge from each individual water closet.
Water connection means the fitting or point of connection for the manufactured home water distribution system designed for connection to a water supply.
Water connector means the removable extension connecting the manufactured home water distribution system to the water supply.
Water distribution system means potable water piping within or permanently attached to the manufactured home.
Wet vent means a vent which also serves as a drain for one or more fixtures.
Wet vented drainage system means the specially designed system of drain piping that also vents one or more plumbing fixtures by means of a common waste and vent pipe.
Whirlpool bathtub means a plumbing appliance consisting of a bathtub fixture which is equipped and fitted with a circulation piping system, pump, and other appurtenances and is so designed to accept, circulate, and discharge bathtub water upon each use.
[40 FR 58752, Dec. 18, 1975. Redesignated at 44 FR 20679, Apr. 6, 1979, as amended at 52 FR 4584, Feb. 12, 1987; 52 FR 47553, Dec. 15, 1987; 58 FR 55012, Oct. 25, 1993]