CFR > Title 14 - Aeronautics and Space > CHAPTER I—FEDERAL AVIATION ADMINISTRATION, DEPARTMENT OF TRANSPORTATION > SUBCHAPTER C—AIRCRAFT (parts 21 to 50) > PART 29—AIRWORTHINESS STANDARDS: TRANSPORT CATEGORY ROTORCRAFT > SUBPART F—Equipment (§29.1301 to §29.1461) > 29.1353—Electrical equipment and installations.

29.1353—Electrical equipment and installations.

(a) Electrical equipment, controls, and wiring must be installed so that operation of any one unit or system of units will not adversely affect the simultaneous operation of any other electrical unit or system essential to safe operation.
(b) Cables must be grouped, routed, and spaced so that damage to essential circuits will be minimized if there are faults in heavy current-carrying cables.
(c) Storage batteries must be designed and installed as follows:
(1) Safe cell temperatures and pressures must be maintained during any probable charging and discharging condition. No uncontrolled increase in cell temperature may result when the battery is recharged (after previous complete discharge)—
(i) At maximum regulated voltage or power;
(ii) During a flight of maximum duration; and
(iii) Under the most adverse cooling condition likely in service.
(2) Compliance with paragraph (a)(1) of this section must be shown by test unless experience with similar batteries and installations has shown that maintaining safe cell temperatures and pressures presents no problem.
(3) No explosive or toxic gases emitted by any battery in normal operation, or as the result of any probable malfunction in the charging system or battery installation, may accumulate in hazardous quantities within the rotorcraft.
(4) No corrosive fluids or gases that may escape from the battery may damage surrounding structures or adjacent essential equipment.
(5) Each nickel cadmium battery installation capable of being used to start an engine or auxiliary power unit must have provisions to prevent any hazardous effect on structure or essential systems that may be caused by the maximum amount of heat the battery can generate during a short circuit of the battery or of its individual cells.
(6) Nickel cadmium battery installations capable of being used to start an engine or auxiliary power unit must have—
(i) A system to control the charging rate of the battery automatically so as to prevent battery overheating;
(ii) A battery temperature sensing and over-temperature warning system with a means for disconnecting the battery from its charging source in the event of an over-temperature condition; or
(iii) A battery failure sensing and warning system with a means for disconnecting the battery from its charging source in the event of battery failure.

Code of Federal Regulations

(Secs. 313(a), 601, 603, 604, and 605 of the Federal Aviation Act of 1958 ( 49 U.S.C. 1354(a), 1421, 1423, 1424 , and 1425); and sec. 6(c), Dept. of Transportation Act ( 49 U.S.C. 1655(c) ))

Code of Federal Regulations

[Doc. No. 5084, 29 FR 16150, Dec. 3, 1964, as amended by Amdt. 29-14, 42 FR 36973, July 18, 1977; Amdt. 29-15, 43 FR 2327, Jan. 16, 1978]